Alberta Seed Source Selection Tool (Alberta3ST)

Alpha version, Feb. 15, 2020, by Zihaohan Sang ✉ and Andreas Hamann ✉.

Home | Instructions

Seedlot selection for Region D1

Select other: Region D | Region D1 | Region E | Region E1 | Region E2 | Region G1 | Region G2 | Region H | Region I

The map displays seedlots that have been tested in this region and match the criteria set below. You can pan and zoom with the mouse wheel. Sources are colored by breeding value (red=low, green=high). The table at the bottom of the page lists the seedlots you see here. The map and table change dynamically as you move the sliders.

Result: seedlots that match the above criteria

You can sort the table by clicking on the headers. Explanations for selected table headers: ACCESSION = Seedlot identifier; SPEC Sw = white spruce, Se = Engelmann spruce, Sx = Sw x Se hybrid; SOURCE = Province/state-CPP region of seedlot origin; HT = Average height (cm) across test sites at the time when breeding values were determined; HT_SE = Standard error of HT; HT_BV = Breeding value (%), where 100% is the average performance of seed sources that originated within the same breeding region, tested under 2000s climate.

 

 

This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.