ypset Command

AIX Version 4.3 Commands Reference, Volume 6

ypset Command

Purpose

Directs a client machine to a specific server.

Syntax

/usr/sbin/ypset [ -V1 ] [ -d Domain ] [ -h Host ] Server

Description

The ypset command directs the ypbind daemon on the client to the ypserv daemon on the server. The ypbind daemon goes to the server you specify in the Server parameter to get Network Information Service (NIS) services for the domain you specify in the Domain parameter. The ypbind daemon gets the NIS services from the ypserv daemon on the server.

Once the binding is set, it is not tested until a client process (such as the ypcat command or the ypwhich command) tries to get a binding for the domain. If the attempt to bind fails, (the specified server is down or is not running the ypserv daemon), the ypbind daemon makes another attempt to bind for the same domain.

Specify either a name or an Internet Protocol (IP) address in the Server parameter. If you specify a name, the ypset command attempts to resolve the name to an IP address through the use of the NIS service. This works only if your machine has a current valid binding for the domain in question. In most cases, you should specify the server as an IP address.

In cases where several hosts on the local network are supplying NIS services, the ypbind daemon can rebind to another host. For instance, if a server is down or is not running the ypserv daemon, the ypbind daemon rebinds the client to another server. In this way, the network information service balances the load among the available NIS servers.

Use the ypset command if the network:

Does not support broadcasting.
Supports broadcasting but does not have an NIS server.
Accesses a map that exists only on a particular NIS server.

Flags

-d Domain	Specifies a domain other than the default domain.
-h Host	Sets the binding for the ypbind daemon on the specified host instead of on the local host. The host can be specified as a name or as an IP address.
-V1	Binds the specified server for the (old) version 1 NIS protocol.

Example

To set a server to bind on a host in a particular domain, enter:

ypset -d ibm -h venus mars

In this example, the ypset command causes the host named venus to bind to the server named mars.

Related Information

The domainname command, ypcat command, ypwhich command,

The ypbind daemon, ypserv daemon.

Network Information Service (NIS) Overview for System Management in AIX Version 4.3 System Management Guide: Communications and Networks.

Network File System (NFS) Overview for System Management in AIX Version 4.3 System Management Guide: Communications and Networks.

How to Configure NIS in AIX Version 4.3 System Management Guide: Communications and Networks.

List of NIS Commands.