DEVICE SELECTION
You must choose the device that you are
developing for. You do this by clicking on the Assign -> Device
menu item. For the UP1 board we are using the FLEX10K Family with
the EPF10K20RC240-4.
There are settings on the side of the screen which you may have
to change depending on your project but that is beyond the scope
of this document. You should make your screen look like the
following:
figure 2.1
Your chip is given the same name as your project
by default. You can change this by choosing the Edit Chips >>
button in the Device
dialog box. After you have selected the device in which you are
using choose OK
and you will return back to the main screen. You are now ready to
compile your design.
Mark Fedorak, Vera Casteel, Kris Pucci, Ron Smith - 1998